Dental FAQs

My implant crown feels loose. Is the implant failing?

Usually not. Most of the time a loose implant crown is a loose screw, or a crown that has lost its cement, while the implant underneath is still firm in the bone. Screw loosening affected 8.8% of single implant crowns within 5 years in a review of 46 studies (Jung 2012), and it is often fixed in one visit by tightening or replacing the screw. The implant has failed only if the implant itself moves in the bone, which a dentist checks by hand and on an X-ray. Stop chewing on it, keep the crown if it comes off, and see a dentist within a week or two with your implant records, because the brand decides which screwdriver and parts fit.

Loose crown or failing implant, at a glance

An implant tooth has three parts. The implant is the titanium screw in the bone. The connector, called an abutment, sits on top of it. The crown is the visible tooth. The connector is held to the implant by a small screw, and the crown is either screwed to it or cemented on. A wobble can start in any of these joins, and the cause decides how urgent it is.

What you noticeWhat it usually isUsual fixHow soon
The crown rocks or clicks, the gum looks normalA loose connector screw or crown screwTighten or replace the screwWithin one to two weeks; stop chewing on it
The crown came off in one pieceCement that has let go, on a cemented crownClean and cement it again, or remake it as a screwed crownWithin a week; keep the crown
The crown moves, and the gum is sore, swollen or bleedsA loose screw with gum inflammation, or a problem with the implantX-ray, clean, then decideWithin a few days
The crown feels firm but has cracked or chippedA break in the ceramicPolish, repair or a new crownWithin a few weeks
The whole implant moves when pressed, often with painThe implant has lost its bond with the boneRemoval, healing, then a new planWithin days

Only the last row is a failed implant. The others are repairs to the parts on top, and the implant can carry on for many years after them. For the wider list of warning signs, see signs a dental implant is failing.

How an implant crown is held on

When the connector screw is tightened, the dentist uses a torque wrench set to the force the implant maker gives. That force stretches the screw very slightly, like a spring, and the stretch clamps the connector onto the implant. This clamping force is what stops the parts moving when you chew (Huang 2019).

Over the first weeks, the tiny high points on the touching metal surfaces flatten under biting forces. The clamp loses a little of its tension as they settle. That is one reason some dentists check and retighten the screw at a follow-up visit, and why a crown that was firm on fitting day can feel loose some weeks later.

  • Screw-retained crown: the crown and connector are screwed to the implant through a small hole in the biting surface, which is then filled. A dentist can take it off without damaging it.
  • Cemented crown: the crown is cemented onto the connector, like a crown on a natural tooth. It looks the same, but it is harder to take off, and the cement can let go.

Neither type is right for every case. Your dentist chooses from the position of the implant, the look of a front tooth and how easy it will be to service later. Ask which type you have and keep the answer with your records.

How often implant crowns come loose

Loosening is one of the most common problems with implant teeth, and also one of the most fixable. The studies give a range, because they cover different implant designs and years.

StudyWhat it looked atWhat it found
Jung 2012, 46 studiesSingle implant crowns over 5 yearsScrew loosening 8.8%, loss of cement hold 4.1%, ceramic fracture 3.5%; 97.2% of the implants survived
Theoharidou 2008, 27 studiesConnector screw loosening on single implants over 3 years97.3% to 97.6% of crowns had no screw loosening, with internal or external joins
Pjetursson 2012, 32 studiesImplant bridges over 5 yearsConnector or screw loosening 5.3%, loss of cement hold 4.7%
Pjetursson 2018, 60 studiesDifferent ways the connector joins the implantScrew loosening was more common where the connector sits on the outside of the implant

The reviews do not fully agree. The 2008 review called screw loosening a rare event when the parts have anti-rotation features and the right torque is used (Theoharidou 2008). The 2012 review, which counted all screw problems over a longer time, put it at 8.8% (Jung 2012). Inner joins, where the connector sits inside the implant, resisted loosening better in the reviews (Huang 2019; Pjetursson 2018).

Implant loss itself is far less common. In a Swedish national study, 2.0% of implants were lost after the teeth were fitted, in people examined 9 years after treatment (Derks 2015).

Why screws work loose

  • The join between implant and connector. Inner and tapered joins with anti-rotation features held better than outer joins (Huang 2019; Pjetursson 2018).
  • The torque. A screw tightened below the maker's setting has less clamp to start with (Huang 2019).
  • Repeated tightening and loosening of the same screw, which a review advised against (Huang 2019).
  • A long overhang. A crown or bridge that extends beyond the implant, called a cantilever, raised the risk (Huang 2019).
  • Heavy biting or grinding at night, which loads the screw again and again.
  • A bite that hits the implant crown first or from the side.
  • Parts that are not the maker's own. Each brand makes its connectors and screws to fit its own implants, and a part from another brand can cancel the implant warranty.

Often more than one of these is at work. A crown that loosens once is usually just tightened. A crown that loosens again needs the dentist to look for the reason, or it will keep happening.

Is the implant failing? How a dentist tells

  1. Looks at the gum around the crown for redness, swelling, pus or a deep pocket.
  2. Holds the crown and the gum and feels which part moves: the crown alone, the crown and connector, or the implant in the bone.
  3. Takes an X-ray to see the bone level around the implant and whether the parts are fully seated.
  4. Takes the crown off if it is screwed, to check the screw, the connector and the implant directly.
  5. Tests the implant itself. An implant that has bonded to the bone does not move at all, even when the crown is off.

A loose screw on a healthy implant shows normal bone on the X-ray and a calm gum. A failing implant usually shows bone loss on the X-ray, and the gum is often inflamed. Bone loss from infection around the implant is called peri-implantitis. It is treatable in its early stages, which is one more reason not to wait.

Sometimes the two come together. A loose crown leaves a gap where plaque collects, and the gum gets inflamed. Fixing the screw and cleaning the area usually settles it.

What the dentist does to fix it

ProblemWhat is doneHow long it usually takes
Loose screw on a screw-retained crownThe filling over the screw hole is removed, the screw is tightened to the maker's torque or replaced, and the hole is sealed againOne visit
Loose screw under a cemented crownThe dentist may drill a small hole through the crown to reach the screw, then repair the hole; sometimes the crown has to be cut off and remadeOne visit, or longer if a new crown is needed
Cement has let goThe crown and connector are cleaned and cemented again, with care to remove every trace of excess cement at the gumOne visit
Broken screwThe broken piece is removed with fine tools, and a new screw fittedOne or more visits
Worn or damaged connectorA new connector of the same brand, and often a new crownUsually two visits

Screw fracture is uncommon. In a study of full-arch bridges, the yearly rate of a broken bridge screw was 0.3% (Papaspyridakos 2020). A broken screw inside the implant is harder to fix, which is why a loose crown should be seen before it breaks.

What to do from Australia, step by step

  1. Stop chewing on that side. A loose crown puts uneven force on the screw and can bend or break it.
  2. If the crown comes off, keep it in a clean container and bring it to the dentist. Do not glue it back yourself, and do not swallow it: if it comes off while you eat, check before you swallow.
  3. Do not try to tighten anything yourself.
  4. Take clear photos of the tooth and the gum in good light, and note when it started.
  5. Send the photos to the clinic that placed the implant and to us. We help you reach the treating dentist quickly.
  6. Book a dentist near you within one to two weeks, sooner if the gum is sore or swollen. Take your implant records with the brand, size and position of the implant.
  7. Ask the dentist to send us the X-ray before any part is replaced, unless it is urgent. Some aftercare terms depend on what the X-ray shows.

Most dentists in Australia can tighten or replace a screw, as long as they can get the right screwdriver and parts for your brand. See will Australian dentists fix overseas dental work and what happens if my dental work fails at home.

Why your implant records matter here

Implant screws are not universal. Each brand has its own screw head, its own screwdriver tip and its own torque setting. A dentist who does not know the brand has to identify it from the X-ray, which is slow and not always possible.

  • The implant brand and model.
  • The size of each implant, and where it is in your mouth.
  • The connector and crown used, and whether the crown is screwed or cemented.
  • Your X-rays from the day the crown was fitted, so a dentist can compare bone levels.

For every implant and All-on-4 case through The Hudson, the genuine brand, size and all details are written down. That is our rule for every partner clinic. Keep a photo of the record on your phone as well as the paper copy.

When the crown keeps coming loose

One loose screw is a repair. Two or three is a pattern, and the dentist should look for the cause rather than tighten it again.

  • The bite is checked, to see whether the implant crown takes too much load or is hit from the side.
  • The screw is replaced with a new one, instead of reusing the old one.
  • A night guard is made if you grind or clench your teeth at night.
  • The connector and crown are checked for wear, cracks or parts that are not the maker's own.
  • A crown with a long overhang may be reshaped or remade.

All-on-4 and implant bridges

A full-arch bridge is held by several screws, one on each implant. If one screw loosens, the bridge can click, rock slightly or let food under it, while the other implants hold it in place. The fix is the same: the bridge is unscrewed, the screws checked or replaced, and the bridge refitted.

A bridge that suddenly feels loose all over can also mean a cracked frame or a broken screw. In one study of full-arch bridges, the yearly rate of frame fracture was 0.3%, the same as for broken screws (Papaspyridakos 2020). Either way, it needs a dentist soon. The wider picture is in All-on-4 problems and failure rate.

Common beliefs that are not quite right

What people hearWhat the studies show
"A wobbly implant tooth means the implant has failed."Usually it is a loose screw or crown. Screw loosening affected 8.8% of single implant crowns over 5 years, while 97.2% of the implants survived (Jung 2012).
"If it is loose but does not hurt, it can wait."A loose crown loads the screw unevenly and can break it, which turns a simple fix into a harder one.
"Any dentist can tighten it with a standard tool."Each brand has its own screwdriver and torque. The dentist needs to know your brand.
"Superglue will hold it until I see a dentist."Glue can stop the crown seating properly and makes the repair harder. Keep the crown and bring it.
"Screws come loose because the implant is a poor one."Loosening depends mostly on the join design, the torque, overhangs and biting forces (Huang 2019).

Questions to ask the dentist

  • Is the screw loose, or is the implant itself moving?
  • What does the X-ray show about the bone around the implant?
  • Will you replace the screw or tighten the old one?
  • Do you have the right screwdriver and parts for my implant brand?
  • Is my crown screwed or cemented, and does that change the repair?
  • Why did it come loose, and what stops it happening again?
  • Do I need a night guard?

What The Hudson does

The Hudson is not a clinic, and we cannot tell from a photo whether an implant is failing. What we do is make sure you leave Vietnam with your implant records, so a dentist at home can find the right parts, and help you reach the treating dentist quickly if something feels loose. Every year for 10 years we check your photos and X-ray for free, with a 15-minute call with Hudson. Each partner clinic has its own aftercare and warranty policy, and we go through it with you before you book.

How we make money

You don't pay us anything. When you go ahead with treatment, the clinic pays us a referral fee for each patient. It doesn't change your price: you pay the clinic's normal price, the same as if you walked in yourself.

Quick answers

Why does my implant crown feel loose?

Usually because the screw holding the connector or crown has loosened, or the cement on a cemented crown has let go. The implant in the bone is usually still firm.

How do I know if it is the crown or the implant?

If the tooth clicks or rocks but the gum looks normal, it is most often the screw or crown. If the whole implant moves, often with sore gum, it may have failed. A dentist's check and an X-ray tell them apart.

Is a loose implant crown an emergency?

Not usually. Stop chewing on it and see a dentist within one to two weeks, or within a few days if the gum is sore, swollen or has pus.

Can a loose implant screw be tightened?

Yes. The dentist tightens it to the maker's torque, or fits a new screw. A screwed crown is usually fixed in one visit.

My implant crown fell out. What should I do?

Keep the crown in a clean container, do not glue it back, take photos and see a dentist with your implant records. A crown that came off whole can often be refitted.

Implant crown feels loose?

Send us a photo and any X-ray. We tell you what to ask your dentist and help you reach the clinic that placed it. Free.

Send my photo